D1 1" D2 1" OAL 4" LOC 1-1/2"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.
D1 1/4" D2 1/4" OAL 2-1/2" LOC 3/4"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.
D1 5/16" D2 5/16" OAL 2-1/2" LOC 3/4"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.
D1 3/8" D2 3/8" OAL 2-1/2" LOC 7/8"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.
D1 1/2" D2 1/2" OAL 3" LOC 1-1/4"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.
D1 5/8" D2 5/8" OAL 3-1/2" LOC 1-1/4"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.
D1 3/4" D2 3/4" OAL 4" LOC 1-1/2"
6 flute end mills are recommended for finishing
passes and can be run at increased speeds and feeds
where a perfect finish is required. Working these mills
hard is a good thing. The Variable Index reduces
the harmonics to allow for fast smooth cutting. The
Eccentric Relief provides a very strong and sharp
cutting edge for a long life and our complex multiple dish angles on the end face makes for an excellent flat and
smooth finish. These end mills are Center Cutting.